If your die doesn't thread in far enough to make contact with the shellholder as described above, you will need an extension. They are available thru Hornady, already noted.
Remember to go from a 500 Linebaugh to a 510 GNR you will only be trimming off about 1/8", so the case won't be protruding much from the die.
-
This may be a dumb question
- Josh t, 2019-12-22, 13:01
![[*]](themes/default/images/complete_thread.png "Open whole thread")
-
Do you need the extension piece?
- WB, 2019-12-22, 13:37
-
As WB stated, you may or may not
- Abin Sur, 2019-12-22, 13:45
-
Where canning get an extension? Nm (nm)
- Josh t, 2019-12-22, 14:08
-
Are you running out of threads or not able
- WB, 2019-12-22, 15:43
-
Both (nm)
- Josh t, 2019-12-22, 15:49
-
Here you go Josh...
- Huey, 2019-12-22, 17:30
-
Here is the scoop
- Abin Sur, 2019-12-22, 18:19
- Thanks guys got the extension ordered (nm) - Josh t, 2019-12-22, 18:36
-
Here is the scoop
- Abin Sur, 2019-12-22, 18:19
-
Here you go Josh...
- Huey, 2019-12-22, 17:30
-
Both (nm)
- Josh t, 2019-12-22, 15:49
-
Are you running out of threads or not able
- WB, 2019-12-22, 15:43
-
Where canning get an extension? Nm (nm)
- Josh t, 2019-12-22, 14:08
-
As WB stated, you may or may not
- Abin Sur, 2019-12-22, 13:45
-
Do you need the extension piece?
- WB, 2019-12-22, 13:37