Reeder Custom Guns - when I order dies I give them all the measurements

gary reeder
when I order dies I give them all the measurements
Saturday, January 04, 2020, 20:14

including the neck thickness of the brass case. So I would recommend staying with the proper brass. Scotty just needs to break down and buy the proper dies and quit trying to afro engineer everything. Nobody can expect to get the decent velocity and accuracy by using junk dies and old brass that has been shot a number of times in some other gun.

I shot the .400 GNR a little, forming cases. - WB, 2020-01-04, 18:41
- A revisit of the whole story... - WB, 2020-01-05, 12:25
- I used 30-30 brass I picked up at the range - Sean Harper, 2020-01-04, 20:35
  - Yeah I'm sure it will. Cast bullets did you - WB, 2020-01-04, 21:14
    - .401”, accuracy with 255,285 gr cast was very good - Sean Harper, 2020-01-05, 08:42
      - I hae a 10mm 230 and a 270 .41 - WB, 2020-01-05, 12:17
- In that case, Starline 38-55 Brass will cure the other issue - Huey, 2020-01-04, 18:44
  - when I order dies I give them all the measurements - gary reeder, 2020-01-04, 20:14
    - Go ahead and get the 400 GNR dies WB lol (nm) - Vern, 2020-01-04, 20:16
      - I will Vern, just having fun playing. - WB, 2020-01-04, 21:40
  - I have not used my pin gauges to check the chamber yet - WB, 2020-01-04, 18:58
    - LOL WB - Sid R, 2020-01-05, 08:52
    - i have 3 or 4 good friends and customers that - gary reeder, 2020-01-04, 20:35
      - Like I said, my ammo was bad. Trying to figure why. - orWB, 2020-01-04, 21:12
        Misfit or Mad Scientist? Hard to tell. (nm) - Woody, 2020-01-05, 00:53
        Is hard to tell the difference, but fun reading! (nm) - Jerry, 2020-01-05, 06:00