Reeder Custom Guns - I know rim diameter on the Single-six chassis

WB
I know rim diameter on the Single-six chassis
Thursday, February 20, 2020, 18:27

is a limiting factor. Have you toyed with smaller rimmed stuff necking down to .30? Like the .38 Super? Just wondering if you have some new ones knocking around. Too bad that .351 WSl brass is not popular it is semi-rimmed, long too. That old fellow back in the 1920's shortened the .401 (semi-rimmed) to make a smoking early 10mm magnum. Minimal rim diameter and case head area.

I kind of want to play with the .321. Much easier to make than the .300 GNR and close in power.

can you say 321 GNR? More on this tomorrow - Gary Reeder, 2020-02-20, 17:55
- I'll take it and the dies. (nm) - Sid R, 2020-02-21, 06:30
- Very nice! (nm) - Andy S, 2020-02-20, 19:22
- Nice! (nm) - Derek, 2020-02-20, 18:31
- I know rim diameter on the Single-six chassis - WB, 2020-02-20, 18:27
  - that 321 is not based on a Single Six. (nm) - gary reeder, 2020-02-20, 19:19
    - we have 5 new cartridges that we have set back until - gary reeder, 2020-02-20, 19:48
      - Gary, How is Dave's 50 cal developing? (nm) - Wayne, 2020-02-21, 07:54
        we are finishing up the prototype barrel this weekend. (nm) - gary reeder, 2020-02-21, 20:12