Reeder Custom Guns - IT might be tedious but I bet you could do the same

WB
IT might be tedious but I bet you could do the same
Friday, December 18, 2020, 11:17

from the correct thickness sheet (basically making some adapters) from perhaps soda can aluminum or brass sheeting.

A .22 Mag case is THICK! I bet a .22 LR case with the web cut off and side split might be better. Tell us Jim.

Down below I mentioned .22LR and .22WMR - Jim Taylor, 2020-12-18, 10:34
- Seem To Recall... - ~JM~, 2020-12-18, 21:17
- I may be full of prunes but I find that - WB, 2020-12-18, 11:14
  - The LR in the photo is about 15 or 18 years old. - Jim Taylor, 2020-12-18, 11:20
- Great job,,, I purchased six 22mag to LR - james, 2020-12-18, 11:05
  - The DIY ones are not always easily re-useable. - Jim Taylor, 2020-12-18, 11:19
  - IT might be tedious but I bet you could do the same - WB, 2020-12-18, 11:17
    - Never tried that. (nm) - Jim Taylor, 2020-12-18, 11:21
      - The MCA adopters are a very thin brass type metal (nm) - james, 2020-12-18, 12:14
        I read about a guy making .41 Colt from .38 Specials - WB, 2020-12-18, 13:40

powered by my little forum