Reeder Custom Guns - that is my reasoning for this..

Gary Reeder
that is my reasoning for this..
Friday, July 09, 2021, 17:00

[image]
[image]
[image]
[image]
[image]
And I have added 2 more Dillon presses since these pics. By the time we close the shops and the gun store, get home and get a bite to eat it is 8PM. So I don't have a helluva lot of time to spare. each of these presses is set up for one cartridge (2 if you count 38 spl and 357 mag). So when I get home I can sit down and crank out 200 rounds in less than an hour and I am ready for the next day at the shop. Most press makers say you can change out calibers in a minute or less but that is pure BS. It takes at least 30 minutes if I change calibers, especially from small primer to large primer and run a test round and so on. We shoot sometimes 500 rounds a week test firing custom guns so I need to load just about every night.

I needed some special bullets for my lion hunt - Gary Reeder, 2021-07-09, 11:37
- Gary sent you an email, take a look. (nm) - bigboar, 2021-07-10, 12:39
  - Dan look up top at my answer. (nm) - Gary Reeder, 2021-07-10, 14:48
- Wow! (nm) - Jerry Ward, 2021-07-09, 15:30
- I just spent an hour surfing the internet looking - Blake, 2021-07-09, 14:15
  - I have a lot of Hornady 300 grain round nose soft point that - Gary Reeder, 2021-07-09, 17:02
- this should quell some of the BS about - Gary Reeder, 2021-07-09, 13:26
  - well I can't say friend, but I am damn proud to - jthomson, 2021-07-09, 20:00
  - I took from it that it's not easy to just re-set up tooling - WB, 2021-07-09, 13:36
    - I talked to another friend that is an ammo maker and he said - Gary Reeder, 2021-07-09, 13:41
      - years ago there was a display at the SHOT Show that - Gary Reeder, 2021-07-09, 13:47
        I'm sure it's the same for oddball ammo. - WB, 2021-07-09, 14:04
        that is my reasoning for this.. - Gary Reeder, 2021-07-09, 17:00