Jim Taylor- For the life of me I can not find
Sean Harper
[subject]
Friday, August 06, 2021, 04:43 (1831 days ago)
your mailing address. Please email me you addy
My email is -spharper at sbcglobal dot net.
Thanks,
Sean
No problem .. emule coming your way ..
Jim Taylor
[subject]
Friday, August 06, 2021, 06:17 (1831 days ago) @ Sean Harper
- No text -
Sean, are your bullets special .22 LR or
WB
[subject]
Friday, August 06, 2021, 09:20 (1831 days ago) @ Jim Taylor
are they Hornet, Bee projectiles using the gas check shank as a "heel"? I figure it should / might work with respect to the .222 bore vs .224".
Not Sean but they are "centerfire" bullets ...
Jim Taylor
[subject]
Friday, August 06, 2021, 09:27 (1831 days ago) @ WB
I am using the gas check step as the heel. The largest diameter you can use is best. Heel bullets are hard to hold without case tension on the bullet body. Priming alone can blow the bullet out of a 6" barrel. I think they work best in a rifle that has a short leade so that the bullet is against the rifling to start with ... or very close to it.
Bullet diameter is not as critical as sometimes it is made out, depending on the application.
224- GC bullets, using the shank as the heel. I do have an
SEAN HARPER
[subject]
Friday, August 06, 2021, 09:31 (1831 days ago) @ WB
Old West (2 cavity) bullet mold that is a 40gr heel bullet just have not cast with it yet.
The 40gr FPGC Jim is using is from NOE molds (5 cavity).
Sean
I ahve a 43 gr. Lyman that I make HP and
WB
[subject]
Friday, August 06, 2021, 14:49 (1831 days ago) @ SEAN HARPER
the LEE 55 gr. FPGC. I need to get back at it. I like the extremes of little and big bullets.
I'll see what I have.