I got the frame pins driven out and the trigger pin. I was able to get the trigger guard off and get the internals out. Also got the hinge screw out so the barrels off the frame.
What's interesting is the trigger return spring and the cylinder pawl spring both have life! I am gonna see if I can polish them.
There are no threads left in the frame where the hinge screws threads. But since the hinge screw is a two-sized screw with a smaller thread area diameter it will be easy enough to replace it and re-thread the frame.
The hammer screw may have to be drilled. I will see after soaking it some more.
-
Progress on the old H&R pistol
- Jim Taylor, 2023-01-24, 16:55
-
This is an interesting product...
- ~JM~, 2023-01-25, 20:13
- It'll strip the bluing, but if I recall correctly - AmBraCol, 2023-01-26, 05:46
-
You might try
- AmBraCol, 2023-01-24, 17:58
-
You don't think heat would weaken it?
- Jim Taylor, 2023-01-24, 18:15
- But of COURSE! - AmBraCol, 2023-01-24, 18:26
-
You don't think heat would weaken it?
- Jim Taylor, 2023-01-24, 18:15
-
This is an interesting product...
- ~JM~, 2023-01-25, 20:13