Reeder Custom Guns - Well my first shots were today.

But I actually lost my front sight retaining screw under recoil. [image] Could someone please send me a link to where I can buy one?

Post reply

Check them and the other screws every now and then as they vibrate loose and are lost.
Gary Reeder

Post reply

I guess I will blue lock tight it in when I receive it?

Post reply

finger nail polish will work.

Post reply

firing of the gun. We always check them as they will vibrate loose. I put a bit of Lok Tite on my guns so they don't come loose. I will get a couple of extra screws out to you tomorrow.
The gun shot a very decent group in the final test shoot. It was about a 2" group at 25 which is excellent for a large heavy recoiling gun. It took me about 10 minutes to shoot that group. Shoot 2 rounds, put the gun down and shake some feeling back into my hand. Then shoot 2 more. Etc.
[image]

Post reply

- No text -

Post reply

Being an ultra high performance platform some fiddling is sometimes needed. Like a dirt bike you can jump the house with, check things after a robust ride! You are flying closer to the sun than most. Depending on your specific loads you may prefer a taller or shorter front blade etc. GNR has those in varied styles. I keep a selection. Check the ejector tube retaining screw, cylinder pin retaining cross pin assy. Of course the frame screws occasionally. You know this but invest in the proper type of driver bits so not to booger the heads. I like the blue loc-tite myself. Comes loose without heat. Red requires heat and green is about chemically welded!

Post reply

- No text -

Post reply

Well my first shots were today.

They are special screws. I will send you a couple.

Oh okay awesome thanks for sending me one or two!

You can use Lok Tite or just some clear

The screws were in there when I did the final test

Alright good deal I'll do just that good shootin right there

Yeah, man that’s a tiger by the tail!

You got that right man