Being an ultra high performance platform some fiddling is sometimes needed. Like a dirt bike you can jump the house with, check things after a robust ride! You are flying closer to the sun than most. Depending on your specific loads you may prefer a taller or shorter front blade etc. GNR has those in varied styles. I keep a selection. Check the ejector tube retaining screw, cylinder pin retaining cross pin assy. Of course the frame screws occasionally. You know this but invest in the proper type of driver bits so not to booger the heads. I like the blue loc-tite myself. Comes loose without heat. Red requires heat and green is about chemically welded!
-
Well my first shots were today.
- 475BISLEY480, 2023-11-10, 16:04
![[*]](themes/default/images/complete_thread.png "Open whole thread")
-
Yeah, man that’s a tiger by the tail!
- WB, 2023-11-10, 20:16
- You got that right man (nm) - 475BISLEY480, 2023-11-11, 08:39
-
They are special screws. I will send you a couple.
- Gary Reeder, 2023-11-10, 16:11
-
The screws were in there when I did the final test
- Gary Reeder, 2023-11-10, 16:19
- Alright good deal I'll do just that good shootin right there (nm) - 475BISLEY480, 2023-11-10, 16:49
-
Oh okay awesome thanks for sending me one or two!
- 475BISLEY480, 2023-11-10, 16:17
- You can use Lok Tite or just some clear - Gary Reeder, 2023-11-10, 16:20
-
The screws were in there when I did the final test
- Gary Reeder, 2023-11-10, 16:19
-
Yeah, man that’s a tiger by the tail!
- WB, 2023-11-10, 20:16