Reeder Custom Guns - pulling bullets

tedt
pulling bullets
Sunday, February 11, 2024, 23:13

This is probably well known but take the collet out of the hammer type and put the shell holder in upside down with the case, screw on the top and pound away. I put a wad of foam rubber in the tip of the tool so the bullets aren't damaged.

Couple interesting inertia bullet pulling tricks - WB, 2024-02-11, 14:25
- pulling bullets - tedt, 2024-02-11, 23:13
  - The only cases I found that I can't pull is the 586 GNR and - Gary Reeder, 2024-02-12, 12:30
    - Yes that is good thinking, considering. - WB, 2024-02-13, 09:03
  - I had read that and forgotten, never tried it! (nm) - WB, 2024-02-12, 08:04