Reeder Custom Guns - On most of the necked down cartridges for a revolver just

Gary Reeder
On most of the necked down cartridges for a revolver just
Friday, June 14, 2024, 10:12

full length sizing doesn't get it. Run the sizer die down hard against the shell holder. Then back the die off and run it down about a quarter turn more so that when the die touches the shell holder it cams over about an inch. This way you full length size the case. The 44 Magnum cases rims vary a lot so to ensure the round is sized all the way you have to let the die cam over on the shell holder.

Blackhawk 41 GNR issue - Smokey Squibbs, 2024-06-14, 08:36
- On most of the necked down cartridges for a revolver just - Gary Reeder, 2024-06-14, 10:12
  - That should solve the problem but if it doesn't then - Gary Reeder, 2024-06-14, 12:11
    - Some shell holders are thicker than others - Blake, 2024-06-14, 14:51
      - Blake is right. Between the extra high shell holders and - Gary Reeder, 2024-06-14, 17:06
        Yep, the cam over wasn't sufficient - Smokey Squibbs, 2024-06-15, 03:37
        That is surprising. The cam over has worked for - Gary Reeder, 2024-06-15, 14:35
        I had to do the same. (nm) - Amede, 2024-06-15, 06:17
        Many years ago I was hunting a lot with the 41 GNR and still - Gary Reeder, 2024-06-15, 11:38
        I noticed the same thing on 30-30 brass when loading for - Sean Harper, 2024-06-18, 08:44
        You guys that are new and maybe don't - Gary Reeder, 2024-06-18, 13:39