cylinder

The .44 mag necked to 10mm, sort of a thinking man’s .38-40. You can hot rod the .38 WCF but you won’t gain more, just risk more.

The front frame relief and recoil shield back were more styling touches paying tribute to the Colt lLightnings and the Croft modded lightweights in the late 1920’s. Notice it is a Reeder #6 (on the std. BH chassis) with Bisley trigger and hammer. The doner gun was a 10-1/2” .44 Mag. Boy it shot good, but it was 2 ft. long!

problem as it is one of our own cartridges that we developed.
I would have to see the factory markings to be able to duplicate it so if you have any paperwork showing the 10mm cylinder that would help. On either of the cylinders I would need the gun in here to build and fit the new cylinder to it. Both of those cylinders would be 6 shot cylinders and would run $325 each plus the shipping back. If the 401 GNR is to be used in the Buckeye revolver then I would only need the one gun.
If you decide to go with it, just box the gun up good and send it to me. Make sure and put the info I need to build the cylinder and I will take care of it.