Reeder Custom Guns - It was a little to one side but too tall front sight

WB
It was a little to one side but too tall front sight
Tuesday, December 31, 2024, 08:25

So as I began shortening it and load testing it also pulled the POI inward as well. When I got to the point I liked the six-O’clock picture and was hitting to my liking, I was good. Factory loads hit a little lower since recoil is not as much but it still right there. Even a lighter than 300 gr., a little faster, hits about the same place as the 300.

Regulating fixed sight guns with loadings is pretty easy when you think about it. Up and down anyway. That right and left is what’s tricky. If you can’t turn the barrel any more you are faced with shaving the correct side of the front sight or rear notch. One goes backward from the other and it’s hard to put back if you make a mistake! Yikes!

[image]

Reeder Gun Porn Display - jthomson, 2024-12-30, 08:26
- I can't play fair, too many... - WB, 2024-12-30, 14:36
  - I knew you couldnt do it hahaha its like an - jthomson, 2024-12-30, 18:26
  - You will be glad to know you have more - Gary Reeder, 2024-12-30, 15:53
    - I do take good care of them. Usually in a fall or drop - WB, 2024-12-30, 17:43
  - That Reeder 20 is a purty gun! (nm) - Jim Taylor, 2024-12-30, 15:19
    - Finally got it regulated. 300 gr.@ 900-1000 fps (nm) - WB, 2024-12-30, 17:45
      - Excellent! (nm) - Jim Taylor, 2024-12-31, 07:32
        It was a little to one side but too tall front sight - WB, 2024-12-31, 08:25
- An OM D.D.! Unique mix of features. - WB, 2024-12-30, 08:48
- My Favorite Reeder Build - Jim Taylor, 2024-12-30, 08:47
- Oh and Happy New Year Misfits (nm) - jthomson, 2024-12-30, 08:27