Reeder Custom Guns - Another question

Dave338
Another question
Sunday, August 10, 2025, 10:52

Because I may have an addiction, I was going through my gun safe and found a contender frame i didn't know I had, so naturally I had to get a barrel for it and I picked up a 35 remington so I could hand load or buy factory if need3d. So.my question is, do you have plans experience with that round in contender? It's a super 14 barrel and im.researching what bullet to use for hand loading.

Under performing - Dave338, 2025-08-09, 17:53
- Your 36 gr of H4895 is LOW, mine takes 39 before I get - Sean Harper, 2025-08-11, 05:25
  - Powder - Dave338, 2025-08-11, 08:07
    - 30 GNR -- O.A.L is 2.950" with a 150gr Nosler (nm) - Sean Harper, 2025-08-11, 10:54
    - By seating the bullet longer it increases capacity - WB, 2025-08-11, 09:43
- What barrel length?? - Sean Harper, 2025-08-11, 05:11
- 322/335 - Dave338, 2025-08-09, 21:32
  - I had expansion issues with .338 bullets - WB, 2025-08-10, 07:01
    - Another question - Dave338, 2025-08-10, 10:52
      - Yeah I’ve had a few, a .35 .336 Marlin too. - WB, 2025-08-10, 14:01
    - Expansion - Dave338, 2025-08-10, 10:27
      - I use the Nosler Ballistic Tip in the .30 GNR - WB, 2025-08-10, 18:25
- Shoot I’m separated from my data right now - WB, 2025-08-09, 19:14
  - Blc 2 - Dave338, 2025-08-09, 21:34
  - Normally I would agree that accuracy over velocity - Dave338, 2025-08-09, 19:44
    - I think I also used H322 and H335 in .30 GNR - WB, 2025-08-09, 20:12