Reeder Custom Guns - .357 with flush wadcutters. ;-)

ORG
.357 with flush wadcutters. ;-)
Friday, May 18, 2018, 13:35

Or a .38 SPL with slightly exposed wadcutters.

Bearcat - CHIPKING, 2018-05-18, 07:48
- I’ll bet it’ll be cool and unusual, that’s the best I can do (nm) - Brent Foy, 2018-05-18, 17:53
- Looks like a 4 shot to me (nm) - Blake, 2018-05-18, 09:38
  - Blake, I also think so! (nm) - BlackPete, 2018-05-18, 15:03
    - 22TMC, stressed a bit linger! To 22GNR - BlackPete, 2018-05-18, 15:08
      - Looking again at the spacing of the cylinder - Blake, 2018-05-18, 16:13
- How about an oldie but goody 32 S&W (nm) - Terry, 2018-05-18, 08:39
  - 9mm Bearcat - CHIPKING, 2018-05-18, 08:43
    - I'm guessing something in 25cal. (nm) - Darryl T., 2018-05-18, 09:31
- or better yet 38 super hmmmm (nm) - jthomson, 2018-05-18, 08:22
  - nope, nope and nope (nm) - Gary Reeder, 2018-05-18, 10:20
    - .38 Special? (nm) - Burban, 2018-05-18, 11:42
      - 38 special is (nm) - Too long, 2018-05-18, 13:26
    - No it’s probably a 17 WSM. Just kidding. (nm) - O’ Gary, 2018-05-18, 11:15
      - as a hint, the overall length of the cylinder is 1.3 - Gary Reeder, 2018-05-18, 12:25
        .357 with flush wadcutters. ;-) - ORG, 2018-05-18, 13:35
        32 s&w long is my guess - Don Clay, 2018-05-18, 13:28
        Just sayin' - Burban, 2018-05-18, 13:13
        45acp is - Too big, 2018-05-18, 13:23
        remember, we are not talking about a Single Six - Gary Reeder, 2018-05-18, 13:45
        OK then, how 'bout something like . . . - ORG, 2018-05-18, 13:58
        Hmmm so that narrows down the possibilites - Amede, 2018-05-18, 12:52
        32 H&R will work just fine (nm) - Kelly Brost, 2018-05-18, 15:11
        I think that would still be too long as the max OAL is 1.350 (nm) - Amede, 2018-05-18, 17:01
        I will be bluing it this weekend so you can see it - Gary Reeder, 2018-05-18, 17:16