Can the cylinders of a Single Six in
O’ Gary
[subject]
Thursday, August 02, 2018, 04:55 (2959 days ago)
32 H&R be rechambered to shoot 327 FM?
Cylinder usually pretty short for the 327 COAL...
Huey
[subject]
Thursday, August 02, 2018, 08:17 (2958 days ago) @ O’ Gary
- No text -
Huey is Correct. Why bother, just load
Fermin Garza
[subject]
Thursday, August 02, 2018, 21:23 (2958 days ago) @ Huey
Your 32 Mag to full cylinder length and you will be right on the heels of the 327 Federal Mag. Before the 327 came along I loaded the 32 Mag as stout as I could and never managed to bend the Single Six. Consider that Gary and his crew can convert the Single Six to far heavier calibers and you will come to the conclusion that the Single Six while small is extremely strong.
Gary and his crew have built me Trail Guns in...
Huey
[subject]
Friday, August 03, 2018, 01:15 (2958 days ago) @ Fermin Garza
250 GNR, 25-20, 30 Carbine, 327 Fed, 38 Super, 40 S&W and 10mm Auto. All are built like tanks and the pride of my revolver battery.
Working on another one now that should raise a few eyebrows in the smallbore realm...
Huey is right. Normally the 32 H&R cylinders are too
Gary Reeder
[subject]
Thursday, August 02, 2018, 10:21 (2958 days ago) @ O’ Gary
short to be rechambered to 327.
single 6
Frank Simon
[subject]
Thursday, August 02, 2018, 13:52 (2958 days ago) @ O’ Gary
Can a .327 cylinder be fit to a ss?
it would have to be longer but then your 32 H&R would not
Gary Reeder
[subject]
Thursday, August 02, 2018, 13:56 (2958 days ago) @ Frank Simon
fit. The cylinder window of the Single Six would have to be wider for the longer 327, so we would have to take the barrel out, trim off the rear of the barrel and then put it back in and adjust the barrel/cylinder gap down to .002 to allow the longer cylinder to be fit in there.