Reeder Custom Guns - Anyone with experience using GNR ammo

From Colorado Custon Cartridge?

They are good people and Bob goes out of his way to make the shooters happy.

things about them. Great people to work with.

We shot some throuvh my Contender and it was a little hot. Had sticky extraction and punctured primers several. They were supposed to be max loads so you might order less than max. That's my plan when I order some 256 Falcon next month.

Post reply

And it has always been a trait of the .25-35 AI, which the .256 is an "Uber" version of. You can chamber and fire a .25-35 Win. in the chamber, once. It typically splits at the shoulder. The brass can't stretch that far in one move. The ammo is even accurate and some lower powered .25-35 almost make it.

Typically we neck .30-30 and it does not need to move that much to form. Ditto for the .30 and 7mm GNR, others...

We once had some form loads from another custom loader. Firing them the cases were partially formed but had blackened dents. This is caused by the load being too light or powder too slow for the job. The case was not sealing at the mouth and gas leaking back made the dents. No harm at all, we just loaded them and finished blowing them out. FWIW

Anyone with experience using GNR ammo

probably half the folks on here have used his ammo.

Not GNR calibers, but I could not say better

At the last spring HHC Gary had

A side note on the wonderful .256 Falcon

Thanks WB

GNR loads

Bob has done several calibers for me. They have all shot wel