Reeder Custom Guns - E D M machining

Frank B
E D M machining
Wednesday, August 21, 2019, 04:22

Cost would be a factor in doing just one set of molds but E D M has been used to cut some some extremely precise designs.

Does anyone know of or think even possible - WB, 2019-08-20, 15:02
- E D M machining - Frank B, 2019-08-21, 04:22
- the first one I know of in that design was - Gary Reeder, 2019-08-20, 17:16
  - Man I'd love to have a boatail 147 gr. - WB, 2019-08-20, 17:22
    - Yeah Miha could probably pull it off, might have - Asa, 2019-08-20, 18:45
      - Miha said the mould was not a problem, but money might be. (nm) - WB, 2019-08-22, 12:34
      - I can't see why CNC can't mill that, simple cross. (nm) - WB, 2019-08-20, 19:03
        Give Tom at Accurate Molds a call - Shawn D, 2019-08-22, 14:44
        Actually. . . email him instead - Shawn D, 2019-08-22, 14:51
  - actually Nate just mentioned that these bullets - Gary Reeder, 2019-08-20, 17:20
- Maybe with zinc - Jim Taylor, 2019-08-20, 15:42
  - We all know a flat point helps transfer energy - WB, 2019-08-20, 16:09

powered by my little forum