Reeder Custom Guns - Scotty you can run two nuts on to the

Blake
Scotty you can run two nuts on to the
Tuesday, October 15, 2019, 17:27

Bolt and lock them together at the trim length. Then grind or cut flush to the nut. You can hold it by the nuts in a vice or with vice grips. Also when you screw the nuts off it will clean up the treads that where cut. May still need a little buffing

Encore barrel - TimC, 2019-10-15, 14:45
- Bullberry dovetails the Encore barrels - steve todd, 2019-10-16, 10:20
- the 2.5" spacing is correct for an encore - Gary Reeder, 2019-10-15, 15:20
  - Works for Pachmayr too. (nm) - WB, 2019-10-15, 17:14
- Should be 8:40 scresws, ACE Hardware has them. - WB, 2019-10-15, 15:07
  - Scotty you can run two nuts on to the - Blake, 2019-10-15, 17:27
    - Best quote of the year! OUCH!! - Steve, 2019-10-15, 18:48
      - Yea must have steel nuts HUA (nm) - Blake, 2019-10-16, 09:33
    - And lock a washer between them to hold it - Darryl T., 2019-10-15, 18:33
      - Just tighten the two nuts will hold it (nm) - Blake, 2019-10-16, 09:30
    - Perfect! Cut-off wheel on dremel, short work. (nm) - WB, 2019-10-15, 17:57