Reeder Custom Guns - Do it with your lathe

stece todd
Do it with your lathe
Friday, January 10, 2020, 10:07

If you have a 5C collet chuck you may have to remove the collet each time to fit the rim of the cartridge, or feed it from the back of the chuck. Will save set up time with a 4 jaw, and be more accurate than a 3 jaw chuck. Make a depth stop if you dont already have one. A crude one with a C-clamp and a piece of angle iron will work. You probably know this already

Do you need a special die to do inside - WB, 2020-01-10, 07:51
- Inside neck ream die - Frank B, 2020-01-10, 13:38
- the only one I have seen was for the original 44 Auto Mags. - Gary Reeder, 2020-01-10, 10:07
- Do it with your lathe - stece todd, 2020-01-10, 10:07
  - I'll tinker with it. My tail-stock is not in good shape - WB, 2020-01-10, 10:14
    - sounds like a personal problem (nm) - Gary Reeder, 2020-01-10, 10:26
    - Hope that made sense - steve todd, 2020-01-10, 10:18