Reeder Custom Guns - Inside neck ream die

Frank B
Inside neck ream die
Friday, January 10, 2020, 13:38

Neck reamed a lot forming brass for wildcats over the years both inside and outside. The die for inside neck reaming is to give better alignment for consistent neck wall thickness. You can inside neck ream with a chucking reamer without the die but they usually follow the existing hole. Your neck wall thickness may not be as concentric. When doing cases in volume would mount a press to good shop drill press. Get alignment as perfect as possible and use drill press.

Do you need a special die to do inside - WB, 2020-01-10, 07:51
- Inside neck ream die - Frank B, 2020-01-10, 13:38
- the only one I have seen was for the original 44 Auto Mags. - Gary Reeder, 2020-01-10, 10:07
- Do it with your lathe - stece todd, 2020-01-10, 10:07
  - I'll tinker with it. My tail-stock is not in good shape - WB, 2020-01-10, 10:14
    - sounds like a personal problem (nm) - Gary Reeder, 2020-01-10, 10:26
    - Hope that made sense - steve todd, 2020-01-10, 10:18