Reeder Custom Guns - I use the acetone method

Chance Dunlap
I use the acetone method
Monday, May 18, 2020, 18:52

I mix acetone with the powder and swirl the bullets around. It works. Bought cheapest toaster oven at Walmart. I use the Lee push through sizers. Never a problem with the coating coming off. Matter of fact in remelt of bad ones the lead melts out before the powder coat burns up. I've been using a blue powder off eBay. I watched a lot of videos before I tried it. Then just did it and figured out what works for me. I cast from range scrap. I add a coating of white label xlox to bullets I like to push over 1000fps.

OK WB, I have been waiting since Friday for you - charlie A., 2020-05-18, 13:08
- Some guys get very technical, I'm very basic - WB, 2020-05-18, 14:01
  - Power coating bullets - Randy Barnett, 2020-05-18, 16:29
  - couple more questions. You say size them in a Lee - charlie A., 2020-05-18, 14:38
    - I use the acetone method - Chance Dunlap, 2020-05-18, 18:52
    - It shold not rub off. Try the Lyman, no lube needed. - WB, 2020-05-18, 18:44
    - I found Lee push through sizer kits as low as $20. (nm) - DinCA, 2020-05-18, 17:08
    - You can use it in a cleaned out lubesizer, just more efficie - Asa, 2020-05-18, 15:13