Reeder Custom Guns - Going to build some base plates for some reloading presses..

Huey
Going to build some base plates for some reloading presses..
Tuesday, June 23, 2020, 06:44

Benches are built from 2 3/4" Cypress and pretty sturdy. But, sizing down jacketed bullets made me consider making the setup stronger.

Got some 3/4" aluminum plates to machine to fit the footprint of each press. Probably overkill, but have to be doing something...
[image]

Going to build some base plates for some reloading presses.. - Huey, 2020-06-23, 06:44
- That should be sturdy! (nm) - ChrisG, 2020-06-23, 08:01
- Wouldn't it be better to extend the footprint? (nm) - Asa, 2020-06-23, 07:50
  - I was referring to the bottom of the press... - Huey, 2020-06-23, 07:55
    - I knew I'd screw that up! LOL! (nm) - Asa, 2020-06-23, 08:04
      - Wasn't you, I wasn't clear. I'll eventually post pics... (nm) - Huey, 2020-06-23, 08:07
        What kind of presses are you swaging these down with? (nm) - Asa, 2020-06-23, 08:23
        Single Stage Lyman Big Orange... (nm) - Huey, 2020-06-23, 08:30
        Havent tried one if those yet, - Asa, 2020-06-23, 10:02

powered by my little forum