Reeder Custom Guns - I was referring to the bottom of the press...

Huey
I was referring to the bottom of the press...
Tuesday, June 23, 2020, 07:55

To the plate. Mainly the rounded contour that sits on the edge of the bench. But, the plates will stay the same size. Both these will more than double the actual contact area. I'll also add bolts to the four corners of the plate.

Going to build some base plates for some reloading presses.. - Huey, 2020-06-23, 06:44
- That should be sturdy! (nm) - ChrisG, 2020-06-23, 08:01
- Wouldn't it be better to extend the footprint? (nm) - Asa, 2020-06-23, 07:50
  - I was referring to the bottom of the press... - Huey, 2020-06-23, 07:55
    - I knew I'd screw that up! LOL! (nm) - Asa, 2020-06-23, 08:04
      - Wasn't you, I wasn't clear. I'll eventually post pics... (nm) - Huey, 2020-06-23, 08:07
        What kind of presses are you swaging these down with? (nm) - Asa, 2020-06-23, 08:23
        Single Stage Lyman Big Orange... (nm) - Huey, 2020-06-23, 08:30
        Havent tried one if those yet, - Asa, 2020-06-23, 10:02