Reeder Custom Guns - I have started using it on almost every cast bullet.

Amede
I have started using it on almost every cast bullet.
Tuesday, October 20, 2020, 13:42

Its almost as good as the powder coating. I was experiencing a bit of leading in a Ruger GP100 44 special with standard cast bullets. Went to using the Lee Alox and now it not only shoots better but the barrel is clean. Like WB says it also works well with muzzleloader bullets, and I use it on a 50 R.E.A.L. bullet.

Took the Model 10 "Parts Gun" to the Range ... - Jim Taylor, 2020-10-20, 11:17
- target - stonecold, 2020-10-20, 14:54
- Sounds like the alloy was funky, too soft/hard?! (nm) - WB, 2020-10-20, 12:36
  - I think its too hard. I will try some other powders - Jim Taylor, 2020-10-20, 12:38
    - That’s always the ultimate option. Lol - WB, 2020-10-20, 12:57
    - Before you recycle them... - JD, 2020-10-20, 12:47
      - I have started using it on almost every cast bullet. - Amede, 2020-10-20, 13:42
        Lol, I cut a mould and gas checked a REAL .50 cal. - WB, 2020-10-20, 16:54
      - That conjures up many naughty thoughts and deviations. - WB, 2020-10-20, 13:03
        Yes .. it does work. I had not thought of it though. (nm) - Jim Taylor, 2020-10-20, 13:09
      - GREAT IDEA! I will try that. (nm) - Jim Taylor, 2020-10-20, 12:56
        Try Lyman #2 alloy. - Alcorn, 2020-10-20, 14:24
        I use TLAR alloy. (That Looks About Right) LOL (nm) - Jim Taylor, 2020-10-20, 16:45