Two ideas. I fitted mine with an almost tight stock, so if the pin walks, it hits wood/plastic and goes nowhere. Second, for the machinist at heart, fit your pins and hole, to be slightly conical, bigger at one end. Then go to idea one.
-
TC Encore hinge pins...
- WB, 2020-12-12, 08:46
![[*]](themes/default/images/complete_thread.png "Open whole thread")
-
personally they are just a gimmick. I have used the original
- Gary Reeder, 2020-12-12, 12:19
- Great point! (nm) - WB, 2020-12-12, 13:08
-
I just use factory pins. I don't have spare Encore Pins...
- Huey, 2020-12-12, 10:07
-
Mostly I have one frame to one barrel but I do have
- Blake, 2020-12-12, 10:56
- Great perspective. They sell the crap out of them. - WB, 2020-12-12, 11:14
-
Mostly I have one frame to one barrel but I do have
- Blake, 2020-12-12, 10:56
-
I just use the stock ones
- steve todd, 2020-12-12, 09:01
-
pins
- joepjs, 2020-12-12, 16:31
- Pin opinion - Mike horn, 2020-12-12, 21:33
-
pins
- joepjs, 2020-12-12, 16:31
-
personally they are just a gimmick. I have used the original
- Gary Reeder, 2020-12-12, 12:19