Reeder Custom Guns - I know there are not a lot of bullet

Mark Conner
I know there are not a lot of bullet
Wednesday, January 06, 2021, 19:37

casters here. But those of you that do cast, how much, if any frost do you like on your bullets?

I personally want a cast bullet to be just starting to show a bit of frost, not a real shiny bullet nor a heavily frosted one. There is not a thing wrong with either side of what I want a bullet to look like, I have shot lots of both. It's just what I try for.

Just a little something I was looking at today and wondering what others do. Hope the picture will show it.
[image]

I know there are not a lot of bullet - Mark Conner, 2021-01-06, 19:37
- I WANT MY BULLETS SHINY AND I - JT, 2021-01-06, 22:12
  - when cast my bullets are shiny (for the most part) - gary reeder, 2021-01-07, 08:48
    - THAT'LL PREACH!! (nm) - Jim Taylor, 2021-01-07, 08:58
  - When i see them start to frost - steve todd, 2021-01-06, 22:17
- Frosty or not... - MQ1, 2021-01-06, 22:10
- I run my lead pot hot and my moulds hot .. - Jim Taylor, 2021-01-06, 21:46
  - Good evening Jim. - Mark Conner, 2021-01-06, 22:33
    - I did it to make them harder ... - Jim Taylor, 2021-01-07, 07:10
- Early on I avoided any frost.. - Curt, 2021-01-06, 20:05
- Look of cast bullets - MTM, 2021-01-06, 20:03
  - Mike, - Mark Conner, 2021-01-06, 21:02
- A little - Cb, 2021-01-06, 19:53
  - I just want them all consistent in a batch. - WB, 2021-01-06, 20:16
    - Depends. No frost on HP's and don't worry about solids. (nm) - Russell Cottle, 2021-01-06, 20:41