Reeder Custom Guns - I did it to make them harder ...

Jim Taylor
I did it to make them harder ...
Thursday, January 07, 2021, 07:10

proven by the hardness tester ..

I know there are not a lot of bullet - Mark Conner, 2021-01-06, 19:37
- I WANT MY BULLETS SHINY AND I - JT, 2021-01-06, 22:12
  - when cast my bullets are shiny (for the most part) - gary reeder, 2021-01-07, 08:48
    - THAT'LL PREACH!! (nm) - Jim Taylor, 2021-01-07, 08:58
  - When i see them start to frost - steve todd, 2021-01-06, 22:17
- Frosty or not... - MQ1, 2021-01-06, 22:10
- I run my lead pot hot and my moulds hot .. - Jim Taylor, 2021-01-06, 21:46
  - Good evening Jim. - Mark Conner, 2021-01-06, 22:33
    - I did it to make them harder ... - Jim Taylor, 2021-01-07, 07:10
- Early on I avoided any frost.. - Curt, 2021-01-06, 20:05
- Look of cast bullets - MTM, 2021-01-06, 20:03
  - Mike, - Mark Conner, 2021-01-06, 21:02
- A little - Cb, 2021-01-06, 19:53
  - I just want them all consistent in a batch. - WB, 2021-01-06, 20:16
    - Depends. No frost on HP's and don't worry about solids. (nm) - Russell Cottle, 2021-01-06, 20:41

powered by my little forum