Reeder Custom Guns - I could see how that would do it. I have several

WB
I could see how that would do it. I have several
Thursday, January 07, 2021, 20:06

But not in that cal. If I had a lever gun I’d probably run and get one. I had a bullet or two that Huey hooked me up with that had a different profile than mine. It’s shallow groove did not lose uniformity in crimping. I think the other just had too deep a groove and the thin brass.

[image]

That Huey bullet might be the ringer for my old Colt limited to lower pressures. The HP boosts validity considerably. I loaded some in .32 S&W too for my little Pocket Positive.

[image]

Why is it hard to get pretty .32-20 necks - WB, 2021-01-07, 15:59
- You need a Lee Factory Collet Crimp die.. - JD, 2021-01-07, 19:43
  - I could see how that would do it. I have several - WB, 2021-01-07, 20:06
    - Have you tried the 30 Carbine factory crimp die? - steve todd, 2021-01-08, 08:13
      - I think the reverse, a .30C in .32 WCF might be possible - WB, 2021-01-08, 14:31
- Thin walls for one thing... (nm) - ChrisG, 2021-01-07, 19:36
  - Chris you are right. Out of 200 primed Starline - WB, 2021-01-07, 20:10
    - good save,,,,,improvise (nm) - Charles, 2021-01-08, 06:14