Reeder Custom Guns - Have you tried the 30 Carbine factory crimp die?

steve todd
Have you tried the 30 Carbine factory crimp die?
Friday, January 08, 2021, 08:13

It might be a little short, but works for 32-20 in a Blackhawk 30 Carbine..isn’t that the “trick” you talked about for using 32-20 in a 30 Carbine, using 30 Carbine dies to load 32-20?
If the crimp is too low, it may help center the bullet, if lightly crimped with the 30 Carbine factory crimp die, and then slowly roll crimp the cartridge, turning the cartridge a little each stage of the crimp.
Then when i think about it, you probably already tried all that

Why is it hard to get pretty .32-20 necks - WB, 2021-01-07, 15:59
- You need a Lee Factory Collet Crimp die.. - JD, 2021-01-07, 19:43
  - I could see how that would do it. I have several - WB, 2021-01-07, 20:06
    - Have you tried the 30 Carbine factory crimp die? - steve todd, 2021-01-08, 08:13
      - I think the reverse, a .30C in .32 WCF might be possible - WB, 2021-01-08, 14:31
- Thin walls for one thing... (nm) - ChrisG, 2021-01-07, 19:36
  - Chris you are right. Out of 200 primed Starline - WB, 2021-01-07, 20:10
    - good save,,,,,improvise (nm) - Charles, 2021-01-08, 06:14