Reeder Custom Guns - Also on LEE moulds, they need lubrication.

WB
Also on LEE moulds, they need lubrication.
Monday, January 18, 2021, 10:10

This manifests itself with misalignment or gaps at the bullet seam. I use paraffin, being very careful not to get any in the mould itself. Lube the locator pins in the mould, and the sprue hinge, handle hinges. Take some time to read those directions that came in the box, old Dick Lee was a sharp cat.

mould problem - carl hackney, 2021-01-18, 10:00
- thanks guys - carl hackney, 2021-01-19, 06:54
- Carl, if you have tried everything listed - Mark Conner, 2021-01-18, 13:58
  - FWIW LEE sprue plate screw is left hand thread. - WB, 2021-01-18, 20:45
- try fluxing it again and really stirring it - Gary Reeder, 2021-01-18, 11:33
- In the winter, i heat the sprue cutter - steve todd, 2021-01-18, 10:39
- That sounds like a too cold pour. - WB, 2021-01-18, 10:07
  - i tried more tin and hotter temps but made little to no - carl hackney, 2021-01-18, 10:27
    - I’m still inclined toward cool alloy or sprue plate. - WB, 2021-01-18, 11:15
      - Might of gotten some zinc in the mix (nm) - Jk, 2021-01-19, 12:28
  - Also on LEE moulds, they need lubrication. - WB, 2021-01-18, 10:10