Reeder Custom Guns - try fluxing it again and really stirring it

Gary Reeder
try fluxing it again and really stirring it
Monday, January 18, 2021, 11:33

while the flame is going. Your mixture sounds like it is bulky and clogging up the sprue hole.

mould problem - carl hackney, 2021-01-18, 10:00
- thanks guys - carl hackney, 2021-01-19, 06:54
- Carl, if you have tried everything listed - Mark Conner, 2021-01-18, 13:58
  - FWIW LEE sprue plate screw is left hand thread. - WB, 2021-01-18, 20:45
- try fluxing it again and really stirring it - Gary Reeder, 2021-01-18, 11:33
- In the winter, i heat the sprue cutter - steve todd, 2021-01-18, 10:39
- That sounds like a too cold pour. - WB, 2021-01-18, 10:07
  - i tried more tin and hotter temps but made little to no - carl hackney, 2021-01-18, 10:27
    - I’m still inclined toward cool alloy or sprue plate. - WB, 2021-01-18, 11:15
      - Might of gotten some zinc in the mix (nm) - Jk, 2021-01-19, 12:28
  - Also on LEE moulds, they need lubrication. - WB, 2021-01-18, 10:10

powered by my little forum