Reeder Custom Guns - Thank You Scotty!

steve todd
Thank You Scotty!
Monday, February 08, 2021, 17:36

That is similar to what i was going to do, once i find that REAL bullet mold. I wasn’t planning on using a gas check, but that will work for now. Thank you for letting me borrow it.
If i can find a mould, i plan to shorten it just a bit more than you have done. Plan on leaving top two bands. How did you do the left hand thread for the sprue plate?

This bullet mould co. Is interesting. - WB, 2021-02-08, 13:44
- Many interesting designs - steve todd, 2021-02-08, 13:51
  - I found it! The mould I modified. - WB, 2021-02-08, 16:01
    - What size gas checks did you use? (nm) - steve todd, 2021-02-08, 18:01
      - Gator short rifle .50 cal. checks. - WB, 2021-02-08, 18:15
    - Thank You Scotty! - steve todd, 2021-02-08, 17:36
      - They do make a 300 gr. .50 REAL too. - WB, 2021-02-08, 18:21
        Valve lapping compound for phillips screw heads - steve todd, 2021-02-08, 21:22