Reeder Custom Guns - I was researching and have not found it exactly

WB
I was researching and have not found it exactly
Tuesday, February 09, 2021, 21:33

but there was an article listed citing the "SLP" bullet mould. One fellow thought he remembered that you cast the nose soft, then inserted it into the other mould and poured a base onto it.

Maybe... the funny nose mould I have does seem to look like it might copy that mould profile. And I guess the configuration of the appendage out the rear might lock it on when you try to cast the base. I do know I had a devil of aa time trying to "double pour" in a conventional mould. The lead would separate, not blend. Until I heated and melted the lead while in the mould with a torch.

Bottom line is you might want this mould I have to complete the set! If it is what I think it might be it would be a very special set for casting.

Who got the NEI 267-375 GC mould? - WB, 2021-02-09, 18:05
- kabukie13 - Carl L, 2021-02-10, 15:53
- 267.375 - Carl l, 2021-02-09, 20:54
  - Carl, if you don't want the point mould I have would - WB, 2021-02-10, 15:42
  - I was researching and have not found it exactly - WB, 2021-02-09, 21:33
- Looks like you set the nose piece in the - Zach, 2021-02-09, 18:30
  - I remember Lyman had a 2-PC pistol mould - WB, 2021-02-09, 18:58
    - I’m sure it would be hard to get a good fill - Zach, 2021-02-10, 14:55
    - About 1985 one of the gun magazines - Bob Denning, 2021-02-09, 21:45
      - That design looks like it would "lock" the to pieces - WB, 2021-02-09, 23:02
        I also tried punching a ragged hole - Bob Denning, 2021-02-10, 07:00
        driving bands - Carl L, 2021-02-10, 16:13