Reeder Custom Guns

Carl L
kabukie13
Wednesday, February 10, 2021, 15:53

at yahoo dot com
I would be interested in reuniting the two molds. Four of the vent lines have tiny dings/divots where they meet the cavities, may fin a little there. I have built a 375 Raptor on an Axis,only have a .27 neck. I was originally thinking the Lee 379-250-RF with a driving band as I described below would work until my cheap self happened on this deal...

Who got the NEI 267-375 GC mould? - WB, 2021-02-09, 18:05
- kabukie13 - Carl L, 2021-02-10, 15:53
- 267.375 - Carl l, 2021-02-09, 20:54
  - Carl, if you don't want the point mould I have would - WB, 2021-02-10, 15:42
  - I was researching and have not found it exactly - WB, 2021-02-09, 21:33
- Looks like you set the nose piece in the - Zach, 2021-02-09, 18:30
  - I remember Lyman had a 2-PC pistol mould - WB, 2021-02-09, 18:58
    - I’m sure it would be hard to get a good fill - Zach, 2021-02-10, 14:55
    - About 1985 one of the gun magazines - Bob Denning, 2021-02-09, 21:45
      - That design looks like it would "lock" the to pieces - WB, 2021-02-09, 23:02
        I also tried punching a ragged hole - Bob Denning, 2021-02-10, 07:00
        driving bands - Carl L, 2021-02-10, 16:13