Reeder Custom Guns - I used some .303 British and it's still a bit small

WB
I used some .303 British and it's still a bit small
Tuesday, March 15, 2022, 17:57

at the base but I go them to work. The very best I found was .444 Marlin brass. But you do not need to work the mouths too much as they will split. Just glue in a overshot card wad.

I made some .45 Colt full cylinder length shot shells from cut off .30-06. I headspaced off the chamber shoulder and made a bit of a necked round, like a .44-40. Once formed they ran fine in the SA. I think I used .30-30's for my .41 Mag. full length shotshells.

SHOTGUN! - Jim Taylor, 2022-03-15, 06:40
- I've long been intrigued by the lowly 410... - AmBraCol, 2022-03-15, 13:18
  - fireforming brass 410 shells - Ray, 2022-03-15, 14:41
    - I saw that... - AmBraCol, 2022-03-16, 07:36
    - I used some .303 British and it's still a bit small - WB, 2022-03-15, 17:57
- Shotguns - stonecold, 2022-03-15, 12:20
- My Grandpa would do - Mark Conner, 2022-03-15, 09:55
- That's good stuff!! - Doctor, 2022-03-15, 07:46
  - Yes a good work! - WB, 2022-03-15, 08:22