Reeder Custom Guns - I think this will work to seat checks.

WB
I think this will work to seat checks.
Thursday, November 03, 2022, 15:55

I screwed a .510 sizer in the press from under with the pusher stuck in the die bore. Then I’m using a .430 “pusher” to mash the bullet into the stop. I tried it both directions. I think upside down may be best.

[image]

Some throw up a little shaved lead from the foot on the shank but I think it’s home and square.

[image]

My continuing fight with the Lyman 450 machine - WB, 2022-11-03, 05:43
- Use RCBS sizing dies... - JD, 2022-11-03, 12:36
- Try first sizing them nose first through a Lee push-thru die - Jim Taylor, 2022-11-03, 06:10
  - The checks are really tight. Once on I think that may - WB, 2022-11-03, 06:23
    - When I sized the 300 gr. 45-90 bullet - Jim Taylor, 2022-11-03, 06:47
      - I think this will work to seat checks. - WB, 2022-11-03, 15:55
      - I used that method for "plain base" checks - WB, 2022-11-03, 07:10
        Years ago Paco sold plainbase gas check maker .. - Jim Taylor, 2022-11-03, 08:37
- try PC with no gc (nm) - Lynn41, 2022-11-03, 05:55
  - The little foot is bigger than the shank - WB, 2022-11-03, 06:19