Reeder Custom Guns - This is exactly the issue I ran into with the 41 GNR

Amede
This is exactly the issue I ran into with the 41 GNR
Thursday, May 03, 2018, 07:44

using the same 410 xtp if I used starline brass it would literally move the shoulder out .001' just enough to keep the base of the case off of the cylinder. When firing that little bit of 'give' would cause a misfire. I also ran them through the FL sizer die again and while this eliminated the case seating issue, it caused the bullets to turn in the case. For those I, lightly, recrimped and fired them. I have since moved to remington brass and the problem was solved. I resized the starline brass back to 44 and use it in my milder loads.

Small reloading speed bump worthy of review - WB, 2018-05-03, 07:33
- Pull the decapping pin out of the sizer die... - Huey, 2018-05-03, 07:45
  - Read a blit closer and I address that trick - WB, 2018-05-03, 08:16
    - I have to do that with all 250 GNR loads... - Huey, 2018-05-03, 08:24
- This is exactly the issue I ran into with the 41 GNR - Amede, 2018-05-03, 07:44
  - A quick fix - Shawn Davis, 2018-05-03, 09:32
    - I've done that to dies in my lathe but your idea - WB, 2018-05-03, 10:04
      - WB will remember that is what I did, milled down - Amede, 2018-05-03, 11:28
  - AND if this were a single shot platform you'd - WB, 2018-05-03, 08:22
    - Yep, and its literally a .001" diff if that. - Amede, 2018-05-03, 08:34
      - Man can't plan for all unseen varibles, only work with them. (nm) - WB, 2018-05-03, 09:01