Reeder Custom Guns - I have to do that with all 250 GNR loads...

Huey
I have to do that with all 250 GNR loads...
Thursday, May 03, 2018, 08:24

But, worth the trouble.

Small reloading speed bump worthy of review - WB, 2018-05-03, 07:33
- Pull the decapping pin out of the sizer die... - Huey, 2018-05-03, 07:45
  - Read a blit closer and I address that trick - WB, 2018-05-03, 08:16
    - I have to do that with all 250 GNR loads... - Huey, 2018-05-03, 08:24
- This is exactly the issue I ran into with the 41 GNR - Amede, 2018-05-03, 07:44
  - A quick fix - Shawn Davis, 2018-05-03, 09:32
    - I've done that to dies in my lathe but your idea - WB, 2018-05-03, 10:04
      - WB will remember that is what I did, milled down - Amede, 2018-05-03, 11:28
  - AND if this were a single shot platform you'd - WB, 2018-05-03, 08:22
    - Yep, and its literally a .001" diff if that. - Amede, 2018-05-03, 08:34
      - Man can't plan for all unseen varibles, only work with them. (nm) - WB, 2018-05-03, 09:01

powered by my little forum