I first ran the 204 brass through a 6tcu die, then too 6.5. I also chamfered the case mouth slightly. As WB said, lube is the key.
-
204 to 240
- Josh, 2020-01-02, 23:55
![[*]](themes/default/images/complete_thread.png "Open whole thread")
-
I make 257 Raptors in one step with no problems
- Blake, 2020-01-03, 07:28
-
...with fresh new brass, right?
- WB, 2020-01-03, 07:52
- borrowed - Paul, 2020-01-03, 13:09
- Yes new brass! (nm) - Blake, 2020-01-03, 10:26
-
...with fresh new brass, right?
- WB, 2020-01-03, 07:52
-
When I was making 6.5 Raptor,,,
- Tim Pence, 2020-01-03, 07:14
- I goofed with annealing, but it causes more problems - WB, 2020-01-03, 07:34
- Idea - Josh, 2020-01-03, 01:10
-
They should work, a little lube inside the case neck.
- WB, 2020-01-03, 00:17
- A cue-tip works well. Adjust the .223's only enough - WB, 2020-01-03, 00:20
-
I don’t have any
- Josh, 2020-01-03, 00:19
-
NO, a collet sizer will not at all.
- WB, 2020-01-03, 00:27
- Thanks (nm) - Josh, 2020-01-03, 01:03
-
NO, a collet sizer will not at all.
- WB, 2020-01-03, 00:27
-
I make 257 Raptors in one step with no problems
- Blake, 2020-01-03, 07:28