Reeder Custom Guns - I’m going to check with LEE, something is up

WB
I’m going to check with LEE, something is up
Wednesday, September 28, 2022, 06:27

The Lee steel sizer works fine. I use RCBS lube pad and no sticky cases at all. I just need 0.003-0.005” tighter sizing for the Hornady cases and 0.499-0.500” bullets. The brass is thick, I mic 0.012” thick at mouth, each side.

I may just need to poop can the LEE dies, go Green. I have a bunch of LEE stuff that works fine. This is unusual.

Problem loading .50 AE, bullets too loose - WB, 2022-09-27, 12:44
- I started a support ticket with LEE we'll see - WB, 2022-09-28, 09:25
- 50 AE Bullet tension - 50GIFreak, 2022-09-28, 07:28
- What with the cost of bullets, etc... - AmBraCol, 2022-09-28, 06:38
- Random ideas - Bob Denning, 2022-09-27, 18:38
- Loaded alot of 50AE when I had a DE, - Darryl T., 2022-09-27, 16:23
  - Also still have a 10inch barrel left. Need to get - Darryl T., 2022-09-27, 16:31
    - That stuff brings good money. I bought a .357 from Puffy - WB, 2022-09-27, 20:51
- I'd try an RCBS .50 AE Sizing Die - Revolvers&1911s, 2022-09-27, 15:45
  - I’m going to check with LEE, something is up - WB, 2022-09-28, 06:27
  - The only reason I suggested the Lee is they sorta specialize - Gary Reeder, 2022-09-27, 15:50
- Our original Lucifer's Hammer revolver - Gary Reeder, 2022-09-27, 14:20
  - Very good point and advise. - WB, 2022-09-27, 14:41
    - +1 for getting a Lee die. I had the same problem - drdougrx, 2022-09-28, 04:42