Screws like that will usually turn right out with your fingers because they no longer have a load on them assuming there is no lock-tite in them or rust. The trick, in this case, is getting ahold of it somehow. Someone already mentioned center punch and drill. If you do that, make sure and use a left-handed drill bit and be sure to drill absolutely along the same axis of the screw. Once the drill bit bites into the screw, odds are it spins right out (if you don't know LH bits drill counter-clockwise).
-
Recommendations on pulling out a
- O’ Gary, 2018-01-31, 19:30
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- not to argue with the guys below, but take it to your local - Gary Reeder, 2018-02-01, 12:12
-
Usually
- Shawn Davis, 2018-01-31, 22:48
- +1 on the left handed drill bit (nm) - Blake, 2018-02-01, 05:17
- If you do not have access to a machine shop - Larry Fry, 2018-01-31, 21:26
-
Drill hole in the screw, follow up with easy out. If you....
- Jeff Spencer, 2018-01-31, 20:05
- Yes a sharp bit and drill press. Whack a divot - WB, 2018-01-31, 21:02