are more thin than typical .30-30 and should help with the thickening brass as it is shortened. I have struggled a bit with .30-30 brass thickness and bullet diameters for the chamber dimensions. The .400 bore is about as far as you want to go on the .30-30.
-
We need a 40 GNR
- Keith, 2022-09-18, 01:05
-
400 GNR in an encore, cut case to 1.8" then load, no problem (nm)
- Sean Harper, 2022-09-19, 09:40
-
You would have to work up new loads but I am
- Sean Harper, 2022-09-19, 09:50
- The Starline .38-55 Win. brass, if you can find them - WB, 2022-09-19, 11:07
-
You would have to work up new loads but I am
- Sean Harper, 2022-09-19, 09:50
- .40-50 Sharps Straight is 1.875 inches - Pacecars, 2022-09-19, 02:57
-
Something larger than .30-30 would be better
- WB, 2022-09-18, 06:13
-
The 30-30/375 Win case is the point
- Keith, 2022-09-19, 10:02
-
Yes .414 would be a unperceivable taper
- WB, 2022-09-20, 07:39
-
I started to get into this "conversation" but
- Gary Reeder, 2022-09-20, 13:33
-
True. As much as I love the odd .400 there
- WB, 2022-09-21, 14:23
- I've the same feelings about the 454 - AmBraCol, 2022-09-24, 15:16
- I don't think the goal is to get 454 performance - Keith, 2022-09-20, 14:20
-
True. As much as I love the odd .400 there
- WB, 2022-09-21, 14:23
-
I started to get into this "conversation" but
- Gary Reeder, 2022-09-20, 13:33
-
Yes .414 would be a unperceivable taper
- WB, 2022-09-20, 07:39
-
The 30-30/375 Win case is the point
- Keith, 2022-09-19, 10:02
-
Or you could use the 460S&W case
- Blake, 2022-09-18, 04:09
-
No problem. All it takes is 12 to 14 months and $2000
- Gary Reeder, 2022-09-18, 14:42
-
The simplest and cheapest way to go is the 445 Super Mag.
- Gary Reeder, 2022-09-18, 14:53
- 30-30 more common 445, 375 Win close enough to 454 brass (nm) - Keith, 2022-09-19, 10:08
- The whole spirit of these laws are to open - WB, 2022-09-19, 06:34
-
The simplest and cheapest way to go is the 445 Super Mag.
- Gary Reeder, 2022-09-18, 14:53
-
No problem. All it takes is 12 to 14 months and $2000
- Gary Reeder, 2022-09-18, 14:42
-
400 GNR in an encore, cut case to 1.8" then load, no problem (nm)
- Sean Harper, 2022-09-19, 09:40