- No text -
-
What are the thought on metal for a HP pin in a mould?
- WB, 2021-02-20, 16:30
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- If anyone desires some 60 yr. old cast bullet data - WB, 2021-02-20, 17:34
-
I would go about 500”
- Randy Barnett, 2021-02-20, 17:04
-
Randy have you done much with the cast HP powder coat for
- WB, 2021-02-20, 17:36
-
I shoot powder coated cast
- Randy Barnett, 2021-02-20, 17:57
-
I figured it would be real clean.
- WB, 2021-02-20, 18:17
-
I hunt with this in my 300 Blackout
- Randy Barnett, 2021-02-20, 19:18
- I sure wish folks would call that cartridge it's - gary reeder, 2021-02-21, 15:36
-
That was not subsonic?! Lol. I guess
- WB, 2021-02-20, 19:22
- 1060 fps from a 10.5" barrel (nm) - Randy Barnett, 2021-02-21, 04:12
-
I hunt with this in my 300 Blackout
- Randy Barnett, 2021-02-20, 19:18
-
I figured it would be real clean.
- WB, 2021-02-20, 18:17
-
I shoot powder coated cast
- Randy Barnett, 2021-02-20, 17:57
- The meplat is about 0.246" and hole 0.115" - WB, 2021-02-20, 17:31
-
Randy have you done much with the cast HP powder coat for
- WB, 2021-02-20, 17:36
-
Plug it and make a nice flat point bullet. (nm)
- Jim Taylor, 2021-02-20, 16:35
-
that is what I would do. A 338 bullet doesn't need to be
- Gary Reeder, 2021-02-20, 16:48
-
At lower velocities it can become a Partition
- WB, 2021-02-20, 16:57
-
Sir Boggs. If you want a partition
- Bob denning, 2021-02-20, 18:19
-
You mentionte that, heat with a propane torch first?
- WB, 2021-02-20, 18:23
- Preheat - Carl L, 2021-02-20, 22:46
-
You mentionte that, heat with a propane torch first?
- WB, 2021-02-20, 18:23
-
Sir Boggs. If you want a partition
- Bob denning, 2021-02-20, 18:19
-
At lower velocities it can become a Partition
- WB, 2021-02-20, 16:57
- That will be one of the first made. - WB, 2021-02-20, 16:48
-
that is what I would do. A 338 bullet doesn't need to be
- Gary Reeder, 2021-02-20, 16:48