Reeder Custom Guns - That will be one of the first made.

WB
That will be one of the first made.
Saturday, February 20, 2021, 16:48

The old pins that survived some other moulds I have use wooden handles with a washer that limits, or makes pin placement consistent. You spin the handle to "lock" the location washer against the pin on the mould and under the lip on the mould bolt.

I'll need to tinker to replicate this on some level.

[image]

What are the thought on metal for a HP pin in a mould? - WB, 2021-02-20, 16:30
- If anyone desires some 60 yr. old cast bullet data - WB, 2021-02-20, 17:34
- I would go about 500” - Randy Barnett, 2021-02-20, 17:04
  - Randy have you done much with the cast HP powder coat for - WB, 2021-02-20, 17:36
    - I shoot powder coated cast - Randy Barnett, 2021-02-20, 17:57
      - I figured it would be real clean. - WB, 2021-02-20, 18:17
        I hunt with this in my 300 Blackout - Randy Barnett, 2021-02-20, 19:18
        I sure wish folks would call that cartridge it's - gary reeder, 2021-02-21, 15:36
        That was not subsonic?! Lol. I guess - WB, 2021-02-20, 19:22
        1060 fps from a 10.5" barrel (nm) - Randy Barnett, 2021-02-21, 04:12
  - The meplat is about 0.246" and hole 0.115" - WB, 2021-02-20, 17:31
- Plug it and make a nice flat point bullet. (nm) - Jim Taylor, 2021-02-20, 16:35
  - that is what I would do. A 338 bullet doesn't need to be - Gary Reeder, 2021-02-20, 16:48
    - At lower velocities it can become a Partition - WB, 2021-02-20, 16:57
      - Sir Boggs. If you want a partition - Bob denning, 2021-02-20, 18:19
        You mentionte that, heat with a propane torch first? - WB, 2021-02-20, 18:23
        Preheat - Carl L, 2021-02-20, 22:46
  - That will be one of the first made. - WB, 2021-02-20, 16:48